Comments on: Nerf Sentry Gun…be afraid.

By: Jeremy Blum

Jeremy Blum — Sun, 10 Jul 2011 01:55:57 +0000

The source and schematics are available above. I’m afraid I can’t write a guide – it would take forever.

By: dkgansta

dkgansta — Thu, 07 Jul 2011 07:30:14 +0000

… about how you make it

By: dkgansta

dkgansta — Thu, 07 Jul 2011 07:24:55 +0000

can you please send me step by step guide if it not to much to ask.

By: Jeremy Blum

Jeremy Blum — Fri, 17 Jun 2011 01:28:59 +0000

Almost any microcontroller will get the job done. A TI launch pad is only $5 and should work for this purpose.

By: Tom

Tom — Thu, 16 Jun 2011 07:03:55 +0000

Is there any where I can get a much cheaper Board of education thing?

By: Jeremy Blum

Jeremy Blum — Fri, 05 Nov 2010 05:09:48 +0000

I think it was a futaba continuous rotation servo… But any normal hobby servo will do. However, you may wish to consider using something with a bit more torque, or even using a stepper, since the servo we used was underpowered for this project.

By: Hamza

Hamza — Thu, 04 Nov 2010 16:01:01 +0000

Can you please tell me which servo motor you used? Will the Standard HITEC HS-311 will work in this project.

By: A.Samad

A.Samad — Wed, 15 Sep 2010 18:35:12 +0000

i have not really worked or studied image processing. so i was hoping if u could just tell me what exactly should be my point of interest while starting/studying DIP. im good with micro controllers so i am really wiling to go for this project. thanks

By: Jeremy Blum

Jeremy Blum — Tue, 14 Sep 2010 18:46:19 +0000

What kind of help do you need? All the info I have from this project is contained in this post.

By: A.Samad

A.Samad — Tue, 14 Sep 2010 07:29:36 +0000

i meant JEREMY :)